重庆升降机提升链起着至关重要的作用，所以保养好提升链条可以延长杭州货梯的使用寿命，保证其使用安全性。下面有关技术人员就给大家详细介绍一下提升链的维护方法。
  
1.链轮装在轴上应没有歪斜和摆动，不允许有摩擦链轮齿侧面现象，如果两轮编移过大容易产生脱链和加速磨损，在更换链轮时必须注意检查和调整偏移量。起重链条的松紧度应适宜，太紧增加功率消耗，轴承易磨损；太松链条易跳动和脱链。
Hangzhou freight elevator sprockets on the shaft should not skewed and swing, does not allow the sprocket side friction phenomenon, if an offset is too large rounds off the chain and prone to accelerated wear, when replacing the

sprocket must be careful to check and adjust the bias shift. Tightness lifting chain should be appropriate, too tight increase in power consumption, bearing wear; the chain is too loose and easy to beat off the chain.

2、货梯新的起重链条过长或经使用后伸长，难以调整，可看情况拆去链节，但必须为偶数。链轮磨损严重后，应同时更换新链轮和新链条，以保证良好的啮合。
Hangzhou new freight elevator lifting chain or by the use of after a long stretch, it is difficult to adjust, you can remove the link to see the situation, but it must be even. Sprockets badly worn, it should also replace the new sprocket and new chain, to ensure good engagement.

3、货梯旧的起重链条上不能与部分新链条混合使用，否则容易在传动中产生冲击，拉断链条。
Hangzhou old freight elevator lifting the chain can not be mixed with some new chain, or prone to shocks in the drive, and pull off the chain.

4、货梯起重链条在工作中要记得及时加注润滑油。而润滑油则必须进入滚子和内套的配合间隙，以便改善工作条件，以减少磨损。
Hangzhou freight elevator lifting chain at work in time to remember filling oil. The lubricant must enter the roller and the inner sleeve with the gap in order to improve working conditions in order to reduce wear.