1、用一根圆钢棍穿过机床的基座，并用一根粗麻绳，在圆钢棍两端各绕几圈，挂在起重机的吊钩上，为了避免损伤机件，必须垫放两块木块。在吊起之前，应卸下手轮、垫圈和螺母。
Hangzhou with a round stick through the freight elevator machine base, and with a thick rope, in round stick around a few times at each end, hanging on the crane hook, in order to avoid damage to Hangzhou freight elevator parts, must mat put two pieces of wood. Before lifting, remove the hand wheel, washers and nuts.
 
2、以煤油洗去杭州货梯防锈涂层，用手摇转手轮使全部活动部分达到全行程，同时，将润滑油涂在滑承面上。
Hangzhou Huoti kerosene wash antirust coating, with a hand wheel to resell part of all activities to reach full travel, while the lubricant is applied to the slide bearing surface.
 
3、重庆升降平台地基的负荷力必须经过试验，在安装前，水泥基础应已经干透并已结硬。在机床底下应尽量多插入铁楔，机床在基础上固定之前，必须用准确的水平仪来校准。水平仪首先校正纵向，随后校正横向。调整机床时，工作台应停放在正中位置，在调整完毕以后，用水泥浆联同铁楔灌满机床底。必须待水泥浆结硬后，才允许旋紧基础螺母，并且要随时注意机床的水平度。
Hangzhou freight elevator load force foundation must be tested prior to installation, concrete foundation should be completely dry and has a hard knot. Hangzhou freight elevators under the machine should be inserted as much iron wedge,before the machine on the basis of fixed, must be accurately calibrated level meter. First level meter vertical correction, and then correct the lateral. Adjust the machine, the table should be parked in the middle position, after the adjustment is completed, the water filled with mud, together with the iron wedge bottom machine. After a hard knot grout must be allowed only tighten the nut base, and to pay attention to the level of the machine.

4、必须按照升降平台润滑表上所规定的时间进行润滑，在启用机床之前，首先要熟悉各操作用的零件。在试车时，把所有在滑轨上的固定装置松开，用手摇转各手轮作全程移动，然后接机动部分。
Must be lubricated in accordance with the Hangzhou Huoti lubrication table specified time, before enabling the machine, the first to be familiar with the parts of each operation. When commissioning, all the fixtures on the slide release, with a hand full rotation turn each hand movement, and then the motor parts.